 Show
The Quadratec® Difference Oil Filter Housing Assembly Quadratec Part #: 51007-0000 OMIX Part #: 17436.52 Description The Omix Oil Filter and Cooler Assembly can remedy a host of problems that you may be having with your JK Wranglers engine oil. This assembly is a direct replacement for use on the 3.6L gas engines in the 2012-2013 Jeep Wrangler and Grand Cherokee. This assembly includes new temperature and pressure sensors, new filter and fresh hardware so you can spend less time trying to salvage old parts. When your engine oil is at the correct temperature it will maintain its properties and last longer, while prolonging the life of the moving parts inside the engine. Details
Installation Notes Installation Difficulty:
Installation Time: 1-2 hours Parts Included 1 Filter
Housing and Cooler Warranty 5 Year Limited Warranty
Customer Submitted PhotosOMIX Oil Filter Housing Assembly ReviewsQuestionsGenuine Mopar Parts, the Right Choice MoparPartsGiant.com offers the wholesale prices for genuine 2012 Jeep Wrangler parts. Parts like Engine Oil , Filter , Adapter / Oil Cooler & Tubes are shipped directly from authorized Mopar dealers and backed by the manufacturer's warranty. Parts fit for the following vehicle options. Engine: 6 Cyl 3.6L. Transmission: 5-Speed Automatic Transmission, 6-Speed Manual Transmission. Something about choose a reliable factory.In the beginning, we produced low-quality radiators from unreliable factories. After tossing and turning, Changed three suppliers we finally found a reliable quality factory. Although they are more expensive, the quality is much better, we can sell them with more confidence now. *** We have changed several suppliers, just to select the best quality products. Please believe that the quality of our products is proven and we will never provide inferior products. Due to Improper installation, some buyers may think that the product has quality problems or non-compatibility problems. It is recommended to search for related videos before installation. Most people have shared their successful experiences, which will also help your installation! Here we find an empirical share from an enthusiastic buyer. Note: You will need a special Oil Sensor Socket for the oil pressure sensor. A regular deep socket works fine on the temperature sensor. The sensors stick out with quite a bit of thread still showing, that is normal. One word of caution of you are doing this yourself without much experience: When it comes time to torque the upper manifold back down (use a torque wrench), MAKE SURE it is fully seated in place. There are 2 pairs of studs that stick out of the driver's side of the upper manifold. Make SURE that BOTH pairs are inserted through the holes in the 2 brackets that they bolt to, BEFORE torquing it all down. I almost missed the pair in the back, the studs were resting on top of the bracket instead of inserted through the holes, about a half-inch lower like they should have been. If I hadn't noticed that at the last minute, I would have most likely cracked my upper manifold when I torqued it all down. torque everything to spec in the right sequence (you can find torque specs and proper sequences online). Maybe you saw some separate sensors pictures. Don't Worry! It was installed in the cooler! These sensors' chip are ceramic chips. All are the best!Sensors was installed using high temperature loctite. The package contains removable silicone protective covers to prevent sensor damage.OE Number: 68105583AF/ 68105583AE/ 68105583AA/ 68105583AB/ 68105583AC/ 68105583AD This Engine Oil Cooler Filter is Compatible with:
|
2012 jeep wrangler oil cooler housing
Related Posts
Copyright © 2024 paraquee Inc.
