Why does my bissell proheat 2x revolution won t spray water

Document

Table of Contents Show

If you are experiencing Low/No Spray, follow these steps to resolve:
Was this answer helpful?
No Spray at Foot | How to Videos | ProHeat 2X® Revolution® Pet Pro
Was this answer helpful?

If you are experiencing Low/No Spray, follow these steps to resolve:

Make sure the cleaning mode is clearly selected
In Express mode much less water is applied, switch to DeepClean mode for more water/formula
- Deep Clean Mode – 1/4 to 1/3 Gallon of formula/water per minute when continuously pressed
- Express Clean Mode – 2/3 to 1 Cup of formula/water per minute when continuously pressed

Remove clean water tank and check that the tank is not warped, damaged, or cracked
- If clean water tank is damaged, warped, or cracked, a new one should be ordered > Go to Parts & Supplies

Over a sink, push up on valve under tank
- Does water come through?
  - Yes > Reinsert tank and firmly push it back into place leaving no gaps
  - No > A new clean water tank cap should be ordered > Go to Parts & Supplies

Has this resolved the issue?
- Yes > Great! Glad we could get you back to cleaning!
- No > Where is there No Spray?
  - Hose > Go to No Spray to Hose
  - Foot > Go to Handle Removal

Was this answer helpful?

If your machine is not spraying through your hose and tool, here are some easy tips for you to troubleshoot.

First, check to make sure the clean tank has water and/or the water & formula mixture in the tank. If your tank is empty, this could be the reason your machine is not spraying. You will need to fill your clean tank again.

Reseat the tank and ensure it sits snug on the machine. This is key for proper flow through the machine.

If the hose still does not spray, it may have lost its prime. Follow the next steps to correct this issue.

Priming your machine is what allows fluid to flow through the system. This is a regular practice for machines with active spray systems.

Turn off and unplug your machine and keep it in the upright position.

Open the Accessory Hose Door and use a standard ball point pen to press into the small, circular, opening. Press until water begins to bubble up. Insert the hose firmly into place until the red button latches into place.

Plug in and turn on your machine.

Take the entire hose below the clean tank to allow the fluid to spray. Without a tool connected to the hose, press the trigger until it sprays strongly. It may take up to 20 seconds before you see the spray.

If you still did not get the hose to spray, you will need to check to see if the pump belt is broken. See our belt changing video for help.

Now that it sprays again, you can attach your tool and continue to spray.

No Spray at Foot | How to Videos | ProHeat 2X® Revolution® Pet Pro

If you have weak or no spray through the foot of your ProHeat 2X® Revolution® Pet Pro, here are some problem-solving tips:

Note: that when cleaning in the express clean mode much less water and formula is sprayed down you can switch modes for a deeper clean

Your clean water tank may be empty
You may experience that your clean water tank will need to be filled multiple times during a cleaning session
- This is normal it just depends on the size of the area you are cleaning
Next make sure there are no cracks in the tank and be sure to only use hot to the touch tap water
- If the tank is cracked or deformed it may need to be replaced
Lastly make sure the tank is put back correctly
If not this could lead to weak or no spray coming from the foot of the machine

Now you're ready to get back to cleaning with your ProHeat 2X® Revolution® Pet Pro